设为首页
收藏本站
 集团新闻
 新闻综述
 公告
 媒体评论
 首页>>新闻中心>>新闻综述
韩国釜庆大学《Carbon》:在气凝胶基复合材料中对齐石墨烯片以增强电磁干扰吸收
出处:材料分析与应用  录入日期:2025-06-06  点击数:174

  1成果简介 
  本文,韩国釜庆大学Yun-Seok Jun等研究人员在《Carbon》期刊发表名为“Aligning graphene sheets in aerogel-based composites for enhanced electromagnetic interference absorption”的论文,研究调查了基于石墨烯气凝胶的聚二甲基硅氧烷(PDMS)复合材料,旨在改善电磁干扰(EMI)吸收。这些复合材料是将 PDMS 渗入通过单向冷冻和热还原法生产的石墨烯气凝胶中制成的。这样就形成了具有高度排列方向的石墨烯结构。在 8.2-12.4 (X 波段)频率范围内,纵向复合材料的吸收屏蔽效能(SEA)为 8.6 dB/mm,总屏蔽效能(SET)为 11.5 dB/mm。另一方面,横向的 EMI 屏蔽能力较低,SEA 为 4.5 dB/mm,SET 为 6.7 dB/mm。这是因为填料的排列方向增加了入射电磁波的内部多重散射,从而增加了传播路径和能量衰减。这些结果表明,控制填料取向可以显著提高石墨烯/PDMS 复合材料的电磁干扰性能。
  2图文导读  

 

微信截图_20250606095822.png

 

  图1.Schematic illustration of experimental procedures and images on each step.

 

微信截图_20250606095831.png

 

  图2.(a) TEM images of GO and (b) XRD peaks, (c) Raman spectra, (d) the survey spectra and (e) high resolution C 1s of XPS spectra for pristine graphite, GO and rGO, respectively.

 

微信截图_20250606095840.png

 

  图3.SEM images of rGO foams and rGO/PDMS composites. (a, b) Longitudinal and (c, d) transverse sections of rGO foams fabricated by directional freezing. (e, f) Longitudinal and (g, h) transverse sections of rGO/PDMS composites produced via directional freezing. (i, j) Longitudinal and (k, l) transverse sections of rGO foams fabricated by non-directional freezing. (m, n) Longitudinal and (o,p) transverse sections of rGO/PDMS composites produced via non-directional freezing.

 

微信截图_20250606095850.png

 

  图4.Electrical conductivity of (a) composites with aligned rGO sheets, and (b) composites with non-oriented rGO sheets.

 

微信截图_20250606095901.png

 

  图5、Schematic of electromagnetic wave interaction and shielding behavior in the rGO/PDMS composite.

 

微信截图_20250606095911.png

 

  图6.Tensile strength and Young's modulus of the composites produced via (a) directional and (b) non-directional freezing, respectively. (c) Stress-strain curves of all the composites and (d) neat PDMS,respectively.
  3小结 
  石墨烯气凝胶是通过定向或非定向冷冻,然后浸润PDMS制成的。通过定向冷冻制造的气凝胶显示出高度排列的石墨烯薄片。在所得复合材料(35L 和 45L)中,石墨烯片垂直于入射电磁波的方向排列,EMI SE 分别为 7.5 dB/mm 和 11.5 dB/mm。与复合材料(35T 和 45T)相比,这些值分别比石墨烯片与入射电磁波平行排列时的 4.9 dB/mm 和 6.7 dB/mm 高出约 53% 和 72%。这种改进归功于对齐良好的结构,它促进了内部多重散射,增加了电磁波传播路径,从而最大限度地提高了 SET。此外,机械测试表明,与35T相比,35L 复合材料的抗拉强度(1.4兆帕)提高了133%,杨氏模量(3.4兆帕)提高了 70%。这些结果证实,控制 rGO 片的排列是一种有效的策略,不仅能提高 EMI 屏蔽性能,还能提高复合材料的电气和机械性能。此外,通过填料排列实现的可调吸收性能为开发新一代 EMI 屏蔽材料提供了一种前景广阔的方法。
  文献:

 

微信截图_20250606095921.png

友情链接: 国际石墨烯产品认证中心IG...   西安丝路石墨烯创新中心   石墨烯产业技术创新战略联盟  

版权所有:北京现代华清材料科技发展有限责任公司 Copyright ©2024 

京ICP备10026874号-16  京公网安备 11010802023401